-
Drawing bench machine with speed control
The machine is build on a very solid metal frame and is employed to draw wire, open tubes even of great dimensions.
The slide has been conceived in such way that with one hand only the wire can be taken and hooked on the traction chain at the same time.
The return of the slide is automatic anche controlled bu motor device.
The “gallery” type chain has a double row of plates.
The traction is obtained with a geared motor.
The machine is also equipped with a device preventing from injuries in case of wire breakage.FEATURES :
- WIDTH 700 mm.
- LUNGHEZZA 6500 mm.
- LENGTH 1290 mm
- TRACTION POWER 1500 Kg.
- POWER SUPPLY 380V (50Hz) + terra
- TOTAL ELECTRIC POWER 2,5 Kw
- VARIABLE POWER (ON REQUEST)
- 1st speed 1,8 Kw
- 2nd speed 2,5 Kw
- DRAWING SPEED
- 1st speed 6,5m/min
- 2nd speed 13m/min
- LEVEL OF NOISE ON THE WORKPLACE 75 dB (A)
-
Drawing machine 11 passages
The machine is designed to meet the needs of wire drawing.
Its function is to progressively reduce the section of wires of noble materials
(gold, silver, etc.) by passing them in the threading die.
The drawn wire is wound onto a reel equipped with adjustable clutch which makes it possible to
prevent the wire from tearing or from being too slow.
The machining area is fully protected by safety switches and is lubrificated by means of emulsified oil .
Features :
Length : 800 mm.
Width: 1900 mm.
Height: 1400 mm.
-
Electronic Skein Decoiler Machine
Electric unwinding machine for chains with electronic speed control .
Features :
Width: 650 mm.
Length : 700 mm.
Height : 1650 mm.
Weight : 20 Kg.
-
Engraving machine
The machine has been designed to impress customized patterns onto the surface (knurling) of metal wires or pipes. The knurling mechanism is composed of a rotating spindle on whose jaws the supports of the knurls are mounted. The wire or tube to be machined slides inside the spindle and is moved by the pulling unit (reel or other element). Depending on the type of pattern to be engraved, two spindle models can be used: with 3 or 4 jaws. In the 4-jaw spindle two to four knurls can be mounted and therefore it is possible to obtain a helix of 2 or 4 ridges, suitable for working with thin wires and tubes. The 3-jaw spindle is suitable for working on pipes and wires with sections wider than 3 mm. Depending on the section of the tube or wire to be machined, guide nozzles with holes of the same diameter must be used to allow correct positioning with respect to the tools. The machine is made of fire-painted box-shaped metal carpentry, inside which all the mechanical parts are installed. The electrical equipment is built into the machine body, while the controls are positioned outside in a position of easy and safe access.
- Length: 650 mm
- Width: 900 mm
- Weight: 150 Kg
- Minimum machinable wire diameter with 2 knurls: 0.8 mm
- Machinable tube diameter with 3-4 knurls: Min. 3 mm – Max 12 mm
Brochure
© 2023 C.R.O.A. All Rights Reserved. 